I still fit them above every Integrated D/W that I fit, no matter what the worktop is made of. They don't need to be drilled to fix them to a...
20 years ago, I turned up on the first day of a Kitchen fit and the first thing I had to do was remove the original kitchen. Got my tools out and...
4" or 100mm ducting is very unusual nowadays for any kitchen extractor. The majority are either 5" (125mm) or preferably 6" (150mm). As you are...
@goldenboy. I always use the Blue underlay. It is part of the warranty stipulation that it is used. The underlay can be rather soft/fragile...
I'd recommend QuickStep as well. Fitted loads and loads of it over many years. They also do a really good selection of matching transition...
Are you planning on fitting it yourself then....????!!!!! If you are seriously contemplating a Solid Surface type top, I would advise you against...
Probably something like Bushboard Encore or something similar. There are plenty of options, but this is the one that I've done a lot of. It has a...
You have a few options,..... Wooden, Granite, Quartz ,Solid Surface (such as Corian, Hanex etc). There are a number of other Solid Surface...
Nwivi, Firstly, have you checked to make sure that the brackets that connect the Fri/Freezer doors to the furniture doors are adjusted...
Kevee, What is the width of the door on the corner unit? 450mm, 500mm or 600mm??? Also, what is the make of the Le Mans type pull-out mechanism?...
Try searching the product I mentioned, it will explain why on their website!
They most certainly are !!!!!! I've worked on a number of properties that have had internal Stramit walls.
Female Chippy, Try searching for "Stramit Walls/Partitions". I believe the company that make them are from Suffolk or Norfolk...???? Good...
Which numpty designed the layout of the new kitchen? Any decent kitchen designer/surveyor should know that it wont fit if the cabinets & worktop...
The majority are 5mm in from the edge of the door, therefore the center of the 35mm dia hole wants to be 22.5mm from the door edge. If you only...
Separate names with a comma.