I'm talking "classic" in relevance to investment & from an investment point of view it would be the market that would determine that. Plenty of...
I think that which specific vehicle it is & what condition it is in would be far more relevant than if it's ICE or not. If it's a sure future...
We currently have a scabby rear patio about 20 M2 that’s concrete slab laid directly on the ground & I’m thinking of replacing it all with block...
Friend had a similar issue which turned out to be a pin-holed boiler. In conrast I've had an ongoing slow pressure leak for years now (top up...
Practice - 110% - did notice that after a while the clutch was disengaging far less than when I started! Don't think that the drill itself would...
Well, job done to a fashion. I bought an Erbauer core drill & can't say that I was impressed. Progress was so slow that I only ended core...
Thanks all.
Thanks all. It's 100mm vent pipe for a tumble dryer & at low level. TCT OK for this or diamond advisable?
I've need to put a 100mm pipe through a cavity wall, I would usually just cut a circle of 10mm holes & clean up with a chisel bit, but it's in a...
Brushes very well worn, replaced them & the machine is working as normal without any interlock cycling.
It's finished the drain cycle & emptied & is stuck at the end of drain / start of spin. I wasn't about when it did this, but I think it either...
Strange - this would be our 3rd Hotpoint & all have required brushes at around the 4>5 year mark. This one is only around 3 years old, so it's a...
I've got a Hotpoint machine with a clicking door interlock that's stuck mid cycle (drain). I've removed the interlock, cleaned the contacts & it...
Separate names with a comma.