It'll be screwed into the chipboard plank that's under the bath. Check to see if it's centralised on the chipboard, if it isn't you'll have to...
It's possible that the support frame isn't centralised where it's screwed on under the bath, the frame shouldn't be sticking out that far as the...
Put some rockwool insulation around it before you fit the panels.
Oh dear... :rolleyes:
Yes, the Toolstation search facility isn't the best. But when you're in the correct department it's all there though. If I searched for a...
Overall the website is good and I like to see product reviews which can be useful. What I don't like is if I'm looking at a list of a particular...
The poor bloke looks to be in a right state. There isn't an easy answer when you have mental problems, it can be so cruel and unforgiving.
Yes, stateit is correct. You wire them in parallel, I did mine last year. If the second bell isn't loud then swap the 2 wires around that...
Check to see if there's an isolation valve on the pipe supplying the cistern, it may not be fully open.
New Zealand, that's where the pic is from. http://www.bathroomdirect.co.nz/shower-bath-door-pivot-xidp437661.html
Condensation isn't really a problem as the panels don't particularly get cold.
http://en.wikipedia.org/wiki/Convection_heater
This forum has a section for alarms, ask the question or search as there's loads of information. http://www.diynot.com/forums/
Awesome. Are you from the US by any chance? ;)
You might want to try on this forum, I'm pleased I found it.:) http://www.diynot.com/forums/
Separate names with a comma.