Recent Activity

Gavin079 replied to the thread Anyone know what this material is?.

it did seem it was a fire break it was a block wall then that running along the top of the wall.

Kitfit liked Astramax's post in the thread How to fit a door in an uneven door frame.

Alright lining! :).....

Gaz12445 replied to the thread New bricks reclaimed bricks?.

Thank you for replying great option

WildCat replied to the thread New bricks reclaimed bricks?.

I have used FLB bricks as an approximate match for old bricks. They are also F2 frost resistant so suitable for garden walls etc. And...

Gaz12445 posted a new thread.

New bricks reclaimed bricks?

Iam building a small retaining wall , pretty low but want the look of reclaimed bricks . Are there any new bricks that have the look of...

Forum: Builders' Talk

Mattyuk replied to the thread Kitchen sink trap and waste heights help.

true, but will it cause other issues/be in breach of any reg re. s-traps vs p-traps?

azizrasul posted a new thread.

Beading

Is it OK to put flexible sealant between laminate flooring and skirting that you use in bathrooms and kitchens? If so, which one would...

Forum: Builders' Talk

spinlondon replied to the thread Multiple pull cord switch failures.

I found in the past, that when MK switches fail you can disable them and draw on the surfaces of the mechanism with a pencil to...

Dave_C posted a new thread.

Bathroom refurb - long 32mm/40mm waste runs

Hi, I'm in the process of refurbishing our upstairs bathroom (1990-built Wimpey house). The bathroom is about 1.4m x 2.7m - the short...

Forum: Plumbers' Talk

LearningDIY posted a new thread.

Penetrating damp

Just bought an old house. It is brick that have been covered with pebbledash and render One of the interior walls is full of penetrating...

Forum: Builders' Talk

Screwfix replied to the thread Kitchen sink trap and waste heights help.

Option A will leave you with a lot more usable room in the unit below the sink.

HarryL1234 replied to the thread Grout Gun.

If you want to match a specific colour, then you need something like...

stevie22 replied to the thread Discs used for flattening welds.

What's wrong with a normal depressed centre grinding disc? Quickest.

WildCat replied to the thread Multiple pull cord switch failures.

Does the switch actually stop clicking when you try to use it? I assume you are making good connections when you wire in the switches?...

TheJay replied to the thread Grout Gun.

Think that'll get close to this colour? You can see the original colour of the finished mortar along with the mixture behind. [IMG]