We're installing a Bosch venting hob in our new kitchen. Is is located in front of a window, ie on an external wall. We'd like to duct it directly...
Hi all, We're installing a Bosch venting hob in our new kitchen. Is is located in front of a window, ie on an external wall. We'd like to duct it...
I'd like to set up a small photography darkroom in my basement, which ideally should have ventilation due to chemical fumes. There's an existing...
Hi replacing an integrated cooker extractor hood. The new one wants a 125mm extractor ducting but the old one was 110mm. Am I ok to just reduce...
Hi there, I would like to find out if anyone knows how to install an extractor fan (60 litre per second, 150mm dia. duct) in a vaulted ceiling...
Hi. Can’t see a bathroom forum, so hopefully this is the most relevant section. I’m looking for some additional thoughts re bathroom extractor...
Hello all, I’m desperate for some advice on how to resolve the following issue. We’ve just bought a 3 bed flat (Victorian house conversion) and...
I'm planning a small off-grid micro-hydro system. There will be a 10mm2 4-core cable for the alternator output and a fibre optic for control...
Hi, I'm looking to dig a couple of trenches for some cable ducting under the driveway - one trench will just have CAT5e, the other will have...
Planning to replace this kitchen. I'd really like to have an externally vented hood. I'd originally hoped to go through the ceiling void and out...
Hi, I am hoping someone has had this issue and has a solution. I bought a vent axia bathroom extractor fan with a 99mm spigot, although the hole...
I just discovered this kind of thing is available in the US. Is there anything similar in the UK that building control would be happy with?...
Hello, I recently had a hole cored through an old stone wall, approximately 75cm. It wasn't a clean cut, a couple of large stones had to be...
Hello, I’m fitting a Zanussi ZHG51251G Canopy Cooker Hood along with new kitchen units. The kitchen is in a single story extension with a tiled...
We are replacing our visor cooker/extractor hood. There are a million models, options etc. And then I need to make sure I can get the right...
My bathroom has a window and a standard mechanical wall fan extraction. I’m looking to add another vent to a Marley Modern Tile Vent (Smooth...
Hi guys Looking to duct a new ceiling extractor hood outside, are there any building regs regarding distance from ducting exit and opening window...
Is it acceptable to allow the extracted air to run into the dead space between the ceiling and 1st floor between the joists. It's a 3 meter run...
Hi all looking for some advice. We have a bathroom fan wall mounted and recently extended out bathroom. I upgraded the fan to cope with bigger...
I've recently bought a house as a bit of a doer upper, and i've found that the bathroom extractor fan is a little bit bodged. The current set up...
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop
