some firms will only supply straight nails as they are cheaper :(
wood never bolt oak tops, just bicky joint and glue, no need 2 post form.
pimps, just like employment agencies :(
once had a house maid backwards :)
me ol shipmates tell me that bobby grey, will b first in the cue. ohh rrrrrr me arties
used 2 make the best routers out!! had the ol 96 for years (now cloned by all )the 177e was the bees knees in its day.
wot i do is run a bicky jointer 2 cut the bottom of the skirting (normally lay down an old trusted kick plate on floors 2 get correct height )then...
iv u were good looking,smart,or even had a brain, u 2 could have been a carpenter, but no u turn up on site with ur level an ten quids worth of...
this odd ball 4 real ,sad ****
general rule is a third of the width.
go 4 the metobo at £199.99, brill bit of gear,even got a laser,and easy 2 carry about.
y not go 4 a 2nd multico m1, will last 4 ever :)
got 2 b private,st georges hill,weybridge :)
any chippie will cut the tops 4 u ,dont b put off iv ur good at diy, just make sure u get level line round kitchen
but the original , would have been curved ramping, not straight lines.
Separate names with a comma.