Think I would take them along to a good plumbers merchant and see if they can match them.
Hmmmm.... I used X400 for about 4 weeks and then flushed it out. Since then my boiler sometimes drips... I am sure these strong chemicals have...
My thoughts on this are to replace the microbore if funds allow. Especially if it is the 8mm variety installed older properties. I have been...
Thanks for the info. I am not at the job just at the moment but will post a picture tomorrow. Thanks again.
Good morning. I am fitting a new toilet shortly and have three questions. 1. The toilet pan only has two screw holes at the rear of the base. Is...
When you say cloth tape? Do you mean something like Duck tape? Or is there a special product for the job? Thanks again.
Hi hoping for some advice. I am shortly to begin replacing my pipework which is blocked (8mm microbore). I am going to use 22mm copper which I...
I had a bedroom like this. I was quite content to purchase a heavy duty textured paper. I just went for one with vertical lines that didn't need...
I think I would strip back to bare wood with a hot air gun and scraper. Then sand, seal, prime and gloss it.
Have found some primed and beaded mdf panels which are affordable. I think they'll be okay with a couple of coats of white gloss.
Yes would rather not move it but you're squashed against the wall when sat. Only going to go a few inches and I have sourced an offset connector...
I am currently renovating a bathroom for a friend. She is on a limited budget and cannot afford fancy bathroom units etc. We are going to purchase...
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop
