I think door quality and hardware are the most important issue. The cabinets rarely fail as properly screwed together and pinned to the walls...
It largely depends on what finish was used originally. If the wood was stained and covered with a varnish then it will be difficult to remove the...
The only way I can see to speed this up a bit is to gang them up. If you lay five or so alongside each other you could at least cut down on the...
You can get around this by clamping on an end piece to help you with the run off, if you have a clamp long enough for the stock you are working...
I have trimmed doors up with a hand plane, electric plane and a router. I find that the router is better in many respects for accuracy. I use a...
It all depends on how much you intend to use it really. The cheaper saws do not have the fine accuracy of cut that the more expensive saws seem to...
There is not a quick way to do this properly. Any finish that has to withstand exterior exposure needs to be good quality paint like DULUX...
I have found bandsaw blades never cut straight after they have been used for curves and probably this might also be true of hard resin based man...
You can use this set in your cordless http://www.screwfix.com/app/sfd/cat/pro.jsp;jsessionid=NGW1ZT4ISPQKKCSTHZOSFFA?id=35920&ts=19693 Ideally...
The important thing about biscuit jointers is accuracy and uniformity in the slots cut. Cheaper jointers might allow slight movement in the fence...
Contiboard is only 12mm thick and, in my opinion, this is really not substantial enough for cam and dowel. Silvermans in Basildon sell 18mm MCP...
Hi Bob, I have done jobs with cam locks and made a simple jig to give the drill centres for the cam housing and the dowel hole. I used a...
It does sound a bit pricey for twelve 6' bays. Get an alternate price for concrete posts,gravel boards and close boarded panels to compare....
I was advised to use PVA for edge strips. It takes a while to go off and there is no instant grab when you apply the strip so you need to tape it...
Difficult to get Vee T&G in this thickness. I used T&G floorboards and then ran the router down the joints with a vee bit. This looked okay but it...
Separate names with a comma.