the im90i takes the old nails just fine
but i havent been able to get spare gas
i googled an american tool, far better than the chamer thing
but at $2500
im sticking with my jigsaw
hence comment dirtydoo
hence comment. cottonwood
ohh....... youre SO racist :)
cant quite see why coping is an american term
i have a coping saw, damm........ its a stanley so it is...
in some parts of australia mdf is used as door linings
due to the nature of the beast, hinge pockets and strike plates are routed in
ive searched the topics but cant find any information on a coping jig for skirting
i seem to remember it using a router with a long thin cutter...
i have checked
not with mrs mike ;)
but doughnuts only become offensive
if they are out of date :)
powernailer suggest nailing centres at 8 to 10 inch
reading things closer, these centres seem to be based on hardwood boards that are 2-1/2...
tanalised timber splinters
15 minutes and the chemicals makes the area go red
this is a follow on from the tilting fillet question
i am expecting some rot to the rafter feet
is there an efficient way of repair / replacement
Separate names with a comma.