I have an old Skil Orca 190mm which is fine on joists. Just as important a consideration is the blade. If your mate hasn't got a good sharp blade...
Are you remembering to place the cornice upside down on the saw? It will be difficult to get results using a hand mitre block, particularly with...
Never had it with mine. Phone Bosch and explain the problem, their aftersales service is A1.
Its called a pair of compasses but I suspect you mean a Trend "Perfect Butt". Several places sell it, try googling it.
I agree a decent gate isn't quite as easy as it seems so a pre made one might be a sensible option. The gate may be better hung from the post on...
Due to blade wander the reverse side of a jigsaw cut doesn't always exactly follow the top, especially with cheaper jigsaws. As you can't cut from...
Its 100mm. I believe the actual rule is that a sphere 100mm in diameter should not be able to pass between them.
Sorry, only use round ones.
Some sites are not providing enough power of any sort. :( Cordless everything and car chargers is about the only foolproof tool kit these days.
Done a few of these. Use oak (or whatever) veneered mdf lipped with a piece of the real stuff biscuited on. Cut out a hinged flap and finish with...
The last sentence should read can't work.
I've done a fair bit for them and chekov and peterob have covered most of the bases. The main problems are very poor surveys that result in...
I would also move the stairs away from the wall.
The newels should really be concreted in. I would lift the relevant slab and after concreting the post in either chuck some suitable shingle down...
I have the DW625 and can't fault it. If you are looking at getting into all sorts of routing projects with jigs and accessories galore I'm sure a...
Separate names with a comma.