Audi-evo will recommend Elastilon adhesive underlay, but I have had real success with Rewmar MS Polymer, pricey but very good. Make sure you...
Sorry and I meant cut the male first and lay it on to cut the female second.
I think anyway. You would need a bit of extra on the new section as the cut line will swing over into the existing top. I think. Bit late and its...
Right picture is up now, I had in my minds eye the 158 being the angle at the wall rather than the front of the worktop if you know what I mean....
Murmacc, I have to be honest I think you are insulting most peoples intelligence and abilities by suggesting that this is the easiest thing in the...
Of course there are people who go on ego trips when it comes to having their van written and obviously there is a tipping point after which it is...
Absolutely agree Chippie, the saw and rails are as near to a perfect setup for cutting to a line as you can get in my opinion, some other festool...
The problem is is the way I read it is that the mitre cant be done because the existing section is flush and rectangular to to point of the angle...
That looks a right old mess, what comes up when you are writing a post isnt what comes up when it goes on!
The way I read it is that the section already in situ is already too short to mitre properly, thus the problem. Thats why i suggested returning...
awkward to do but what I would do is return the postform along the short edge so it meets the postform on the installed piece, I have to be honest...
if you are a medium sized company (say four employees or more) then a nice liveried van is a must. if you are a one man band, then a liveried...
How precisely would you set up a chainsaw for production work like this?
Thats what opinions are all about. The point about production work is that the less setting up and the less room for error there is the quicker...
Handy I am sure you can do a few the way you are suggesting, but the way to make money on production work is to make things as simple as possible,...
Separate names with a comma.