Phatz, well done, you changed the gate valve between 18:04 and 22:03 on the 30th September, whilst writing these posts and picking your nose....
John, Here is a link to a picture of how i done mine. Basically like the other posters said. It goes through a flyover and then up into the...
I would be a little concerned that if this plumber can be devious in the supply of the boiler. Who is to say that he is not devious with regard to...
In ceramic tile you can get away with a normal masonry bit. Switch hammer off. To get up to 15 mm I would use 2 smaller pilots first, Say 8mm then...
Hey Mr X. Don't use contact adhesive. Instead, apply loads of PVA to the worktop edge, Roll the edge strip out whilst pressing with a hot iron....
The reason you would require a cavity try or some DPC bridging the cavity and sloping towards the outside wall is so the any condensation from the...
As an alternative, could you run the pipes down the wall behind the radiator and then connect at the bottom in the normal way. Depending on the...
Ignore that last comment, Just googled Automatic bypass valves and got the answer. ;)
RE: Bypass. Does the bypass not allow the water to bypass when it should be going round the system as designed? Or, can you get an electronic...
The problem you then have is when the pump overrun kicks in to take the heat out of the boiler after the HW and CH have stopped calling for heat,...
Guys, can somebody get the other end please? This is killing me. ;)
I did put an inhibitor in when i filled the system but due to having to drain it down again I guess most of it has gone. The system has been...
Jay, You would normally fit a standard door frame in the gap with the opening side flush to the wall edge that the door opens into. The rest of...
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop
