The pump is on variable speed setting 3. I read ufh boiler temp should be 15c higher than the ufh setpoint. I could also raise the setpoint of...
Do you have specific concerns about any Radiators not getting hot enough?
Boiler is set at 69c (Economy optimal condensing). Tribune Cylinder is set at 60c UFH Manifold set at 55c. Would increasing the Main Pump speed...
Yes the UFH Zones are 16 and 9 sq m respectively.
Looks like the flat heads screws are for tightening the fitting, possibly an olive in between the plates.
My set up is Ideal Logic heat only 12kw boiler Kingspan tribune Unvented cylinder integral Wilo Pico Variable speed Pump 4 Zone Valves,(Cylinder,...
Make sure the baloon pressure is checked annually. I expect that reduction in pressure accelerates failure.
For clarity; Problem Identified. Leaking Expansion Vessel for the Domestic Hot Water, baloon had failed so nowhere for the expansion to go.
If possible Id check with a neighour and see if theyve had there system plumbed the same way. For me the Plumbing sounds incorrect. We had a...
My old dears ecoTec plus 937 which is 8 years old has developed a leak from the Rear Left hand Domestic Pipe Gromit dripping frequently, more...
Did you return the manifold under warranty as defective?
What's an economical option Soundproofing wise to fill the gap? Knauf 50mm rolled Insulation?
I havent considered a membrane! The Spec calls for 2 layers of Staggered jointed intumescent Mastic sealed Firelining.
Separate names with a comma.