At some point Danny you just have to go out there and do the job. Start small, gain confidence and get you face known. Gradually the work will...
Just got in from the pub so my answer might be a little rubbishy. You have made a traditioanl roof and the rafters are striking the ridge...
I can only echo what Unit says. Cheap work is cheap for a reason.
Yes, there is a jig that can be used for this type of latch. It's made by Trend and fits into their big lock jig that's used for mortice locks....
Hey up Longboarder. Firstly you are a skilled man. You're a proper woodworker with the ability to make articles from wood. The next step is to go...
Why not get your trowel out, mix up some gear and lay some blocks? If you're concerned about the infill on the arch bit then simply pull it down...
There are a couple of options. A shoot bolt with a padlock but at the end of the day it might invite trouble from "the idiots." You could buy...
Makita, Bosch both very good jigsaws. I always think the Bosch is a bit of a handful but boy is it accurate. However I'm having a love affair...
I think what you mean is a gambrel roof. It would be, in my view, virtually impossible to place a flat roof on a pitched roof in the way you...
I would get 2 pieces of 100x50mm attach them between 2 of the trusses as noggins about 600mm apart. Then get a piece of 18mm plywood and screw the...
I think the problem is that the product has been laid in a commercial kitchen. As Audio says laminate just isn't meant for such an environment....
My advice is buy a new angled version. They are really good, save time, make a good job BUT they can be easily damaged. I don't know if the...
Fnuggit, what's the matter with you? How did you go on for a green card by the way?
Apparently Leica are the tops. I've seen one used in a demo but, like you, fained illness when the price came up. Try our hosts they aint bad...
The best grade of cls (canadian lumber size) is c24. This grade is arrived at usually by scanning and inspection for defects, twists, warping and...
Separate names with a comma.