crossed posts with you Cordless. Sounds like silicone may be strong enough on its own?
I should have mentioned that there's UFH under the tiles, so I'm not going to risk drilling through them. Guess my only option for the front L...
Got an integrated dishwasher at the end of a run with a decor end panel to go next to it, to finish the run. Tiles are already down. I can fix the...
Thanks cosworth. Yes, you are correct in saying that I've cut the voids along the male length. I hadn't thought of just measuring the depth of the...
Just want to check I've got this right, so opinions appreciated... - Doing a mitre joint on laminate tops with out of square walls. Male needs to...
A laser is one of those things you use once on the job then put it away until the next time. You don't strictly need one, but they do make the job...
Are there any no-no's with regard to choice of silicone for worktop joins, sink cut-outs etc. High or low modulus? Acetoxy or neutral cure? Or...
My preferred method is to spur off the nearest socket in 2.5mm T&E into a switched fused spur and then run a 1.0mm T&E buried in the wall...
For under unit strip lighting where's the best place to put the socket and a suitable switch. Would you screw the socket to the underside of the...
There's just an integrated dishwasher going in. My real dilema is whether to go for option 2 or 3. Option 3 will make it easier to remove the...
Tiled floor onto 18mm ply going in after units fitted. Dilema - do I: 1. Leave units at standard height and scribe the plinths 2. Put the legs...
Separate names with a comma.