Hows the best way to mark the points ?

Discussion in 'Engineers' Talk' started by Habeohtjt5555, Jun 24, 2018.

  1. Habeohtjt5555

    Habeohtjt5555 New Member

    Right......... I have a small penny washer 50mm with a 6mm hole in the centre. I want to mark out a small equal sided and equal angled triangle in the centre, the points of the triangle will be drilled with a 6mm drill bit, each point is to be 10mm from the outer edge of the washer, Hows the best way to mark the points ? or work out the size of the triangle ? thanks
     
  2. dcox

    dcox Screwfix Select

    Hopefully the attached will help. Print it out at 100% and cut and stick it on to a washer and centre punch and drill the three 6mm holes for the points of the triangle. Then I'd use that washer as a template to mark up the others.
     

    Attached Files:

  3. DIY womble

    DIY womble Well-Known Member

    Posted at 4 in the morning , someone's had interesting night
     
  4. sospan

    sospan Screwfix Select

    Clearly a wind up from an ex-member .....
     
  5. dcox

    dcox Screwfix Select

    Glad I didn’t waste my time then...
     
  6. DIY womble

    DIY womble Well-Known Member

    I like to reply to the slimming posts , but I'm getting p155ed off that they don't reply back
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice