Mortar only under padstone.
Slate or steel shims between pad and lintel.
It sounds like the wrong sized steel/lintel has been fitted.
You need an S/E to calculate the new lintel ( structural works ) which will carry...
You will need to ply over for a decent finish, the boards will show through the rubber.
Put a perforated felt layer on first ( lightly tacked )...
If the footings/brickwork have all been done, it should have a PRC certificate, if it has then go for it.
All structural works need to be done to regs, in your case a Structural Engineer should sort this for you.
Alex, if its an 06 or earlier model get shot of it, nothing but trouble with gear boxes, clutches , steering racks and pumps.
Then get a decent...
If the damage is deep, pva then bond it out level.
You haven't said if its new or old board, or previously skimmed.
Whichever, Febond Blue-Grit...
Straight cut in render.
Stepped in brick.
Tile backer board ?
You cant sand/cement render over p/b
It will be okay, flaunch up the back of paviors.
Celcons, and no good for out side, even if rendered.
The ridge can be re-used with dry system, battens need extended on the ridge via metal clips for ridge clips to be screwed down.
If its for...
If the walls are sound, either 2 coats of pva or 1 blue grit, then 2 coat skim.
Why would any one buy this.
Dust bin lids have been around for many years.
Unless its 50mm p/c you cant walk on it,
Youngmans spanned across.
4 soft yellow builders sand, half snowcrete ( white cement ) and 1 lime.
Will give a cream/sandy coloured mix.
You should be on a minimum £120 a day keeping 3 trowels going.
Have a read about Max Quaterman ( Super Hod ) for any one that can remember him....
Your right in using a plastic bag over the sponge.
The mix needs to be thinner, dip your finger and thumb in the mix, when pulled apart should...
Normally, conection is made at invert level, via a slipper into existing channel.
Sounds like you already have a tumbler, ie pipe half way up...
Separate names with a comma.