Is the one they call the electricians bible brown cover edition ? nice one .Im calling 1st thing
you can get T&G pvc cladding in wickes
sheets of solid plastic /perspex mastic,d to wall!
the long bits are called horns and as taffy says you cut them off
if you have plasterboard ceilings these count as a fire barrier if you have lath and plaster you need to replace or plasterboard over top a lot...
dont know but if it isnt an sds drill bit I wouldnt call it a hammer bit .I know some diy drills are percussion type but they call them hammer.To...
get a cheap circ saw from £20 by the time you burn it out youll know what to look for use a guide as mentioned above but do invest in a couple of...
I had a similiar problem in my kitchen rcd + mcb tripping at different times eventually found several cables with insulation gnawed thru but had...
there are two considerations .general lighting and task lighting general is just that general purpose usually overhead ie an array of spots or a...
Ring circuits are usually done by the amount of floor area they serve a 32a 2.5 cct is standard unless you have to de rate the cable for some...
yeah i also engrave my tools with a soldering iron. also bring most nickable stuff in at night back your motor up against a wall Sometimes i...
as above needs a proper site appraisal major point is the ducting. needs to be on or near an outside wall loft would be good if its a gable ie...
Never thought about this b4 and at 1st thought it was a wind up but a normal tape measure you hold it in yr r hand belt clip at back and pull tape...
why not just put in a rcd
I think your talking about fused spurs lots of wholesalers sell cheapo old fashioned MK lookalikes theyre all fine and match in quite well
I agree any sparks knows this stuff already
I was quoted this in Luton!
I think you need to get above and below pipes will be notched into top so you could remove from below cabling probably wont have jb youll have to...
£37 pm face and £18 block
Yeah they are the nuts you need to cut out where they go I drill a few holes inthe mortar course with a 10mm sds bit squiggle it around a bit...
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop