I would buy a new one. If its hard of cast, you wont be doing it any sence with your machine. Cast and hard steels can be a pain, it will...
Tis easier to remove a bend form something once its past 90degs than it is to increase the angle to get it to 90degs.
Estate Agent Yeah, it must be difficult knowing that nearly everyone you ever meet thinks your a *. [Edited by: admin6]
Get down the newsagent and find a copy of MAXPower :)
Nah, let the old duffers carry on... the ones that really want a hiding are the ones that drive round on L plates without a proper instructor.......
Mig is one of the most usefull ones. MMA is a bit harsh for automotive. Gas is old hat, and bit more difficult to master. If you want to...
Tap...nut...?
You'll need to find the centre too work from, tape the washer down then mark the centre. Use dividers or compass to mark the PCD of the centre...
If theres not masses of torque which i doubt, you could put a nut either side tightened against the gear. Or drill and tap the gear, then lock...
I have used a 'toolshack' a couple of times, fast service. Just remember to add the vat onto the prices ;)
Compounding uses a harsher abrasive than tcut. Such as g3 paste/liquid. Commonly used for flattening paintwork, blending and similar. Its pretty...
10ft overhang isn't massive, as long as the rest is capable of holding it.
When you say inverter welder.... A lot of new welding equiptment is inverter based, MMA, TIG, MAG,... Im guessing your after a small MMA...
You can get ready made kits from some agricultural suppliers. Some are hard work to put up though. If you have the time and equiptment, why not...
I reckon them 'special' bits that they sell on tele shopping channels would do it... if you blunt it or break it, they will send you a new one ;)...
Have a look around machinery sellers, theres loads of secondhand metal bandsaws about, most are fairly cheap. Something like a startrite meba,...
Buy the plates from a fab shop, theyll band holes in it wherever you want for about £1/hole
Id be inclined to get a spare from the manufacturer rather than messing about with it. Zinc alloy is **** to weld whatever, it has a tendancy...
I had tons of screws, then bought a trade case later on when they were on a special. For generall use i just use the turbogold screws, they are...
SF do lift of brackets, anygood? http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=A332898&ts=42521&id=11423
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop