one i did a couple of years ago was from a big DIY warehouse, no idea what make but had a few problems since the install, cracked overhead shower...
yes a slight fall in the horizontal run would be ideal , how far is the garage going to be from the drain ? i would suggest the saniflow would...
put a 110mm pipe into the garage but use this as a duct for a cold water pipe and a drain pipe from a saniflow , as its only a sink a cheap...
unfortunately the capn is right :(
yes you can use speedfit connectors , you can also use compression fittings, if you use speedfit make sure if you are joining onto copper to use a...
could you do a air pressure test to find the leaky pipe ? judging by the cost of 10mm copper pipe now it would cost a few quid to replace it !!...
i have seen a condensate dropped onto a pitched roof flashing and it has discoloured the lead
as the capn says a bodge ahoy, best to route the mdpe inside and join onto copper there, preferably with a isolating valve, you could use a mdpe...
ideally have the dropper closer to the 900 rad if poss as its 10m from your intended route
i would say a max of 3 rads for a 15mm pipe, what size are the rads ?
Antony. what size is the coil ? diameter ? could you fit a new coil ( original manufacturers) or make one with coiled copper pipe, should last...
the blocks you show sine are concrete , i have always heard of breeze as thermalite blocks, as you say * to fix too ! [Edited by: admin]
firstly do you have a prv fitted on the cold mains supply to the coil in the cylinder ?? this is a common problem on this type of unit,...
do what you want until the neighbours blow you up to the council
plane the peak off, as you say have them bowing up and remove the high point
Just be grateful you aint got Thermalite block! :( breeze blocks are thermalite sine, colloquial terms. have heard of cinder blocks , think...
small wire brush
you can get a non return that fits on the hose for the bath mixer , s/f sell em. no need for additional nrv on the shower as most have em built in
last balanced flue i saw was 10 years ago, that was old stock too
have a look at plumbworlds site , in the shower head wall brackets section they have a bar mixer fitting kit, its 2 loose parts that you use after...
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop