I have a £650,000 contract starting in March. Doesn't mean * really as you might end up being a busy fool. (no offence OP) The only time to...
no.
Maybe I'm over laying my experience as a site fore / project manager onto a minor domestic job. On looking back over the op's original post and...
Teuchter. * [Edited by: admin]
My point is that most situations can be resolved amicably by taking a pragmatic and reasonable approach. Not every mistake requires a knee jerk...
I suppose you were too tight to pay for a full scaffold lid. So what did you want the roofers to bl**dy do. You have to accept some culpability in...
Dan, You are totaling wasting your time asking for a ball park figure on a forum, as any figure given will have no relevance without someone...
Who could do such a thing? Slight over reaction don't yer think ? Hate to think what your reaction would be to finding a serious fault....
Why don't you ask your LABC? Pretty obvious why really :)
all sounds lovely. Not
So you're willing to pay petrol to travel and collect an offcut of cornice, and bung some bear money, instead of buying a full length now and...
You'd be hard pressed to beat a paslode. Had mine for 3 years and abused the cr@p out of it. Apart from de-gunging the gas chamber occasionally,...
£15K. You're about to get a reality check. I'll give you a clue. It will be more than double that :(
He could quote to do the floor construction as well :)
SOLUTION If your putting a screed floor down on top of the celotex, this will typically be on a slip membrane, and to a depth of 70mm with...
but leave a 10mm gap at the perimeter walls Correct. :)
Bear in mind though Debbie, your architects recommendations aren't always necessarily the only method of compliance. They tend to stick to what...
Oh, and yes these dwarf walls do require there own foundations (as opposed to building straight off the grass !!!) Don't forget to cross...
Just laid a block and beam floor set off a wall. Inner skin was 120mm wide concrete blocks, with solid cavity in fill to standard outer skin....
Just snip a few strands off to make it fit in the smaller hole. Simples...... :-D
Separate names with a comma.