Difficult to comment without seeing it, any pipes below sub floor at that point? You could biscuit join or dowell it (no visible fixings)...
Regardless of anything we may say, it's your bc officer that needs to be satisfied, you can approach him in a very humble manor, state you really...
Ok if it's just roof structure and a few courses that's not so drastic, hopefully your beam will be an easy lift Good luck
I use celotex or similar slabs without the 6mm plywood as I don't like it, I overboard with 12 or 18 for a better job Important thing is that...
I hate the degree comment, I've heard similar stuff before, and you may have put more work into learning your trade than he did his degree...
As above answer, not the kind of job to do first time just with Internet advice as there are so many factors I assume it's the back wall of...
I often cut tapers free hand on my big table saw on site, key safety issue is that your foot stance should be that even if you push hard your body...
I replaced the stairs in my house and fitted 41mm because I had some baserail going spare, but most stairs I order and fit for clients are 32mm...
If I'm to fit a door later then I often plumb the hinge side then splay the lock side slightly adjusting it over with wedges or packers once the...
allow enough time and make sure you've all the screw bits you need patience, thought and tea
Ive just got the big kit bag for all my Li Ion kit, seems to work ok
+1 Unless you want shed loads and need to compare prices, or need to find somewhere that cuts to your requirements, then buy it wherever
IF you wish to comply to regs, at least in the areas I work, you will have to either raise the floor to get DPM and insulation in, or break out...
Whilst I agree there are a number of ways of doing most tasks, battening and tiling where you know a velux is going only to strip it off and cut...
Wickes sand is rubbish, although some of there products are good
Get the installation instructions from velux, if you dont have the window, you may be able to download a PDF? If it is going into a new roof...
As per my HBXL topic I am desperate to get the best user friendly software around to produce building plans The intended use is domestic...
yes
just brush of the blocks and throw the drywall adhesive at it, it sticks very well if mixed properly and you use enough We do however always...
I will assume this thread is not a joke Even if you can separate the compartments and refit some sort of insulated housing to the separated...
Separate names with a comma.