Still same idea but replacing the 18mm board with a 12mm over a 50cm strip and finish it with self levelling compound and still cut a 30cm wide of...
I am currently laying down a new floor with engineered wood (boards are roughly 20cm x 200cm). Underlay is 3mm thick. When lifting the old carpet...
Just heard from Ikea, they do custom sizes. standard 246cm is £55, 300cm is £240! for 54cm extra. I'd rather ask a joiner (maybe better than me)...
I was planning on buying from Ikea, they seem to only do 63.5cm wide. The island is 90 x 120. Also I need a 3m length, that might be another...
Is it possible to use a router and worktop jig or any other technique to assemble 2 worktop pieces of 63cm wide to make a kitchen island 95cm...
You might have nailed it... the chimney breast was removed on the right hand side (side of crack/gaps) on the first floor an ground floor. I will...
Forgot to mention, there are no crack/gaps on the other side of the gable end and seems to be only on that layer of bricks
The house was extended in the 80's. They kept the existing gable end, put a whole through, an RSJ on one side to access the rest of the loft. We...
My shower enclosure is mostly frameless. Aluminium on the side, glass only at the bottom. In my en-suite (sealed only outside) I can see water...
I just wonder why the instruction manual for shower enclosure always say do not seal inside in capital/bold letters! I always did it. Last time I...
I am using a sealer (LTG impregnating sealer) to seal polished porcelain tiles like required by the tiles manufacturer. I waited 20min like...
Is the air intake for the air pump under the bath? I am fitting bath panel that I am tiling, do I need to leave a gap for fresh air to circulate?...
The corner of the tray if laid flat will be higher than the outside edges, see picture, +8mm where the waste is and +6mm on left. Compensating...
It is a low profile tray so wanted to keep it this way. Just wondering about the additional slope if could negatively affect anything. Ideally not...
I understand that a tray should be levelled and flat as the tray is built with a slope taking the water to the waste. My issue is that I end up...
Try some chemicals. While being in the lockdown I suggest trying a delivery from amazon and read the reviews or post questions there. I used in...
Some development. I found more tiles scratched around the edge (one side only) from the box. I have already used 4 (hence my post), 2 will be...
See the picture, it only shows because it reflects so much. I tried baking soda on an off-cut but it is very easy to take the shine off and make...
I have tiled less than one wall and noticed some scratches on the tile edges, probably when I cleaned off the excess adhesive. I don't tile often,...
Hardiebacker and tanked it with waterproofing kit (primer+tape+membrane paint). I will tile it with a little slope. Maybe less spacing than...
Separate names with a comma.