Thanks for all replies. I think there is some confusion with what I am doing. I am not proposing to put a consumer unit for the shower in the...
Hi I am installing a 9.8kw shower using 10mm2 cable back to 45amp at CU. My question is; all the plumming pipework is in plastic. Do I need to...
Thanks for reply but I have already got the plywood up. Is there a problem with using it or what can I do to it. Thanks KBG
Thanks for reply. Yes the pump is located under the bath (zone1) and I am putting in a new split load cu so will make sure that the bath FCU is...
Hi I am putting in a bath with pump for spa effect. It says it must be earthed but doesn't make it clear if that means just the standard earth in...
Hi all I am putting in a new bathroom which will have stud walls. There will be a shower over the bath and I intend to tile the walls all around...
Hi all thanks for all your replies. In answer to question of if test the same ends of the yellow wire, I had done a continuity test before and...
Hi all, Here's one to test you! I have just installed a 2 way 3 gang light switch. I ran 3core + earth to the switch. I have connected 2...
I have just done the same thing. I have a TT system and did not want to have timed RCD etc so called supply company to ask if my supply would be...
thanks for advice. unfortunately came home yesterday and all covered in scratch coat with no waterproofer. today he's applying top coat with no...
thanks for advice. Do you know if just soft sand and cement is correct? thanks KBG
Hi all I have had an extension built which is being rendered. The guy doing it is using soft sand and cement. Is this right as I thought I...
Hi Plugwash Is it ok to use 1.5m for main light circuit and then 1.0m for switch drops? Surely the 1.0m is carring the same current as the 1.5m?...
Hi I had the same problem, wanting to install 2 10.5kw showers. Firstly when I study the box although it said 10.5kw it actual is rated at 9.8kw...
The person who told me was the guy who came to the property to advise if I could change to PME system from TT. I also had them come to shorten...
Can I throw in a question about this earthing. I am installing a new water supply pipe which is connected underground to an old lead pipe. The...
Hi Unphased I have already spoken to supplier who said I should get the switch installed myself and they are happy for me to pull the main fuse...
thanks for reply. is there nothing smaller and purhaps cheaper that will do the same job? I only have a small board for it to fit on....
regarding the fuse I think there is a calculation for fuse size depending on length of meter tails. thanks
Hi All I need to extend my 25mm meter tails to the CU to about 3.5m. I understand that I need to run these as a sub main after the meter etc....
Separate names with a comma.