Curious one ... Digging around tracing some wiring, I found an ABV. The strange thing is that the heating pipes essentially form a Y; feed comes...
So here's what happened to me recently ... Roof on a building I'm responsible for had a leak and needed repair. It's an hour's drive away and I...
I'm after some help identifying an equivalent TRV head. [IMG] [IMG] Some have Danfoss on the tops, others are blank. They must be at least 25...
I'm swapping out a 2kW undersink water heater in a cupboard in a toilet. The existing flex will be too short. I'm lothed to replace it with a...
[IMG] This is a picture of the underside of a Worcester Bosch 35CDi II. Wall to the left, front of the boiler to the right. Is the large brass...
I've a service valve that hasn't been turned in years, and when I tried, nothing. [ATTACH] [ATTACH] And the slot seems well chewed. Any tips on...
I'm back to thinking about changing my banisters for something less 70s. The current newel post has a definite bend to. My thoughts are to cut it...
I'm looking for a mains 24hr timer spur that only powers up when another mains circuit has power applied. Has anyone come across such a thing as...
I'm planning to replace my newel and handrail at some point this year and I've been having a look at the construction but I'm a bit puzzled about...
Ground floor hallway of a 70s house with a suspended timber floor. Work will be done on wiring, plumbing etc. so most of the T&G floor will come...
Ignoring the electrical zones where an extractor can be located, are there building reg requirements for location and venting? My reason for...
It has been brought to my attention that our front door is "naff" and is to be replaced. SWMBO has spoken therefore it has been added to the list....
10l unvented water heater with a 6 bar pressure relief valve. Drain from PRV goes through an external wall and is visible from outside. Does...
I had some basins (Anadia 42.5 x 32) delivered late this afternoon so haven't had a chance to call the supplier. [ATTACH] The photo on the...
Are there any rules or conventions to decide whether a FCU should be switched or unswitched?
Engineer popped round to service the boiler at my office this morning but did a safety check thinking he needed to issue a CP12. He said there...
Ok, maybe a numpty question, but what type of screws are best for screwing down 18mm chipboard floor panels? I want to tighten up some panels that...
I'm going to replace some internal doors in our house and could do with some advice about where to place the hinges. The original doors were...
I noticed detectors in an office roof void today. I don't know if they were fixed temp, rate of rise or smoke detectors. Can anybody...
To parade my duffer DIY credentials, what sort of clips do you use to secure 6243YH 3 core and earth 1.5mm² cable to wood?
Separate names with a comma.