Ordinarily, you lay the boards at right angle to the joists. Then work out the cuts to best effect this.
Are the roof tiles of the concrete type? because from what i can see the purlins have been strengthened and the verticals were probably put in to...
Well its probably reached its mechanical ability to do the job. It would have more mechanical power if the post was bolted to deeper joists, even...
Are the threads on the bolts all the way down to the head?
If the door has some heritage value, then it will lose that if any kind of repair work is obvious. Perhaps the gap was cause by removing the...
I do similar jobs to this. I use a Hitachi MV12E. For the price its a decent all rounder. To make the jig I would cut the handle outline into a...
sadolin do a product which slows down the natural darkening process for a few years. for the exterior the outcome is a mix of darkened areas, some...
This might be useful http://www.trfastenings.com/pages/Home
Decent build, skirtings on floorboards. Temporary display area, skirtings on carpet.
How was the plastering done? Solid throughout or dot and dab?
Most of the available screws are called pozi and are driven by a no2 pozi bit. this works for no 6 8 and 10 screws. dry wall screws are driven by...
Righty ho. The orientation for me would be diagonal from bottom hinge, up to outer edge. There are however a few configurations for such doors and...
For this I would expect to take out the bath before doing any reworking. Then you can get to all the bits you need to work on.
usually for a typical domestic situation its two spindles for each tread. The horizontal distance between the newels is the relevant part of the...
Yes you need the backing pad. Have a Ronseal moment. They are designed for steel.
http://www.screwfix.com/p/alox-fibre-disc-115mm-60-grit-pack-of-10/37145
I tried the DeWalt D26453-GB. and it seems okay for general lightweight finishing sanding. But if i need to do a lot of removal i use an angle...
There is something a bit odd about this. For it to be a door frame, it would not have come with raised edges on both sides of the frame. Only on...
My decking was treated and waxed when supplied from the timber merchants. So I will probably use a wax product, if and or when I get round to...
There isn't much left to fill, so most of the standard fillers will come out at some point.
Separate names with a comma.