Hi, For some reason in the past the actuator on the primary flow valve has been removed and the valve just left open with the thermal cut out not...
I have a "cold" flat roof in which we are taking the ceiling down, so want to use the opportunity to renew the very thin original fibre glass...
I have a room lit by two 12 halogen downlighters and a third "conventional" tungsten fitting. I want to change this third light to low energy...
just tap the mcb with the end of a screwdriver, it might stop the buzz, if not, bang it a bit harder. How do you know which mcb is buzzing as my...
Thanks for replies (pretty sure not wasps JP) This is a MK CU. I do have a some Wylex 16A MCBs. Would they fit or not? Jon
I have just replaced cable to 3kw immersion heater due to age of original cable. On reconnection, the 16A MCB is buzzing when the heater is...
Just a note on BES. Ordered on line in afternoon and received parcel next morning. Good service
Can't really do that, property is bungalow with hot water tank on ground floor, and only practical to run new pipework in roof space. so would...
I am fitting this extractor fan: http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=100593&ts=48699&id=15061 in the loft space above the...
Thanks BB, looks perfect. Does the valve also act as an isolating valve? If I need to fit a separate isolating valve, does it matter in what...
The hot and cold supply to my ensuite is pumped (Monsoon 4.0 bar pump) This is great for the shower and bath filler, but water blasts out of the...
Am having an installation tested and inspected at "1st fix". Can someone tell me what this means before I go to far. e.g. do entire cable runs...
Since posting this I have read in another thread that all bathroom circuits will soon have to be RCD protected. Is this true? If so when from?
I am in process of installing a new en suite for myself. Involves drainage, new window and electrics (lights, extractor fan, undefloor heating)...
Thanks M107. I will assume it is not a safe zone. I do need to chase into front wall. Do I have to used conduit as opposed to galv capping? and...
Built in cupboard (i.e. a recessed opening in a blockwork wall with a door) Opening is from about 60cm above floor up to ceiling. I want to run...
You winking at me JP??
Why rcd protect the in line fan.... it has no conection to the bathroom... apart from air. I guess myanswer to that question is why not? My...
And another thing............ Fitting a 45W in line extractor fan with separate switch (i.e. not switched by bathroom lighting circuit). I am...
Bongbong: why definitely not on RCD side. Not questioning your knowledge, would like to know the reason.
Separate names with a comma.