Hi, For some reason in the past the actuator on the primary flow valve has been removed and the valve just left open with the thermal cut out not...
I have a "cold" flat roof in which we are taking the ceiling down, so want to use the opportunity to renew the very thin original fibre glass...
I have a room lit by two 12 halogen downlighters and a third "conventional" tungsten fitting. I want to change this third light to low energy...
I have just replaced cable to 3kw immersion heater due to age of original cable. On reconnection, the 16A MCB is buzzing when the heater is...
I am fitting this extractor fan: http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=100593&ts=48699&id=15061 in the loft space above the...
The hot and cold supply to my ensuite is pumped (Monsoon 4.0 bar pump) This is great for the shower and bath filler, but water blasts out of the...
Am having an installation tested and inspected at "1st fix". Can someone tell me what this means before I go to far. e.g. do entire cable runs...
Built in cupboard (i.e. a recessed opening in a blockwork wall with a door) Opening is from about 60cm above floor up to ceiling. I want to run...
Am fitting IP65 12v downlighters in bathroom (Zones 2 & 3) together with "demista" mirror heater which will be sealed behind tiled-in mirror....
I have a bungalow with "traditional" gas boiler and cold water header tank in loft and hot water tank at ground floor level in airing cupboard....
Does anyone know if there exists a cat 2 louvre type fitting which does not cast a shadow at the top of the room. Application is for a shop which...
Fitting a concealed gas meter box (am posting here as same question would apply to electricity meter box) into the outer leaf of a cavity wall...
Fitting a concealed gas meter box into the outer leaf of a cavity wall (Corgi / Gas board doing the meter move, I am just fitting the box). The...
Hi, I need to run power to electric gates. My query isn't about the wiring as such, but I am not clear as to what the regs require re routing. My...
Here's a good one for you. My electic oven is on its own circuit (32A mcb) of 6mm cable. Because we in a bungalow it is quite a long run of about...
Do I need Supplementary bonding on a brass co-ax outlet connected to a roof mounted aerial? There is a sticker inside the plate saying it must be...
Should I run a telephone cable down a chase intended for mains ring main? (to be plastered over). If I do, is there a separation requirement? The...
I need to add extra sockets to a ring main. The room has a solid/parquet floor and inaccessable ceiling void so I will need to run the cables...
Separate names with a comma.