I'm talking "classic" in relevance to investment & from an investment point of view it would be the market that would determine that. Plenty of...
I think that which specific vehicle it is & what condition it is in would be far more relevant than if it's ICE or not. If it's a sure future...
We currently have a scabby rear patio about 20 M2 that’s concrete slab laid directly on the ground & I’m thinking of replacing it all with block...
Friend had a similar issue which turned out to be a pin-holed boiler. In conrast I've had an ongoing slow pressure leak for years now (top up...
Practice - 110% - did notice that after a while the clutch was disengaging far less than when I started! Don't think that the drill itself would...
Well, job done to a fashion. I bought an Erbauer core drill & can't say that I was impressed. Progress was so slow that I only ended core...
Thanks all.
Thanks all. It's 100mm vent pipe for a tumble dryer & at low level. TCT OK for this or diamond advisable?
I've need to put a 100mm pipe through a cavity wall, I would usually just cut a circle of 10mm holes & clean up with a chisel bit, but it's in a...
Brushes very well worn, replaced them & the machine is working as normal without any interlock cycling.
It's finished the drain cycle & emptied & is stuck at the end of drain / start of spin. I wasn't about when it did this, but I think it either...
Strange - this would be our 3rd Hotpoint & all have required brushes at around the 4>5 year mark. This one is only around 3 years old, so it's a...
I've got a Hotpoint machine with a clicking door interlock that's stuck mid cycle (drain). I've removed the interlock, cleaned the contacts & it...
Thanks for the suggestions. Didn't consider sleeving a new hopper in, I'll see if I can get something that suits & failing that glue together &...
It's got what was a shiny / glassy exterior, so I think so. I was thinking along the line of repair cement or the likes, but doubt it would get...
Don't know if I've got the terminology correct, but my gutters run into clay hoppers / gullies / shoes & these have a single vertical pipe that...
I get the impression that the shape wont be so comfortable or the size so small. I think the rope is reserved for upsale.
That's a fair point, but we are talking Kubota not Liebher & equipment rental prices give an (overstated) estimate of equipment costs. Agreed on...
The contractors are private, but need to be SWQR approved to work on the councils pavement. Council are unable to provide a list of approved...
I'm considering putting in a driveway & need a dropped kerb, I have got a couple of quotes from the council approved local-ish contractors & I'm...
Separate names with a comma.