I guess i wont really know if the damp problem has cleared up unless i use some kind of endoscopic camera to look through the vents from outside,...
Ok thanks guys, slight bit of info i didnt say was that these pics are from about 4 years ago! Thats when i discovered this problem when i...
That is what im hoping for really, is some guidance on how i can resolve what i think the problem is that the block paving is too high where it...
Hi, Ive got a problem with the front of my house which im looking for a bit of advice on please. Specifically the block paved driveway seems...
A few pics of the cartridge showing the damaged o-rings and the rough casting
Recently fitted a new thermostatic bar shower in my house and after less than 3 months it has started dripping!?. I stopped it for a bit by...
I find it hard to believe it was still wet after 2 months? Most plaster will be dry enough to paint after roughly a few days to probably max 2...
Stick with one brand of paint i would, although your least likely to have any problems just painting some plasterboards tbh. Johnstones is rated...
Its stickdown lvt btw not the click stuff
So they dont show through the vinyl mate? Seen it done on site, they usually use a latex floor leveller to feather out the joints and hide the...
Hello, My question if anyone can answer it is-is it ok to fill the screw holes and blend the joints in a plywood subfloor with 2 pack wood...
Ok, firstly i think you probly went about it the wrong way using the foam to try and fill a relatively large surface area and try and get it flat,...
Personally i would cut it in one go with the plunge saw face down to get the best long edge without any step. Make sure its got a fine cut, sharp...
They look like they do a job,that is- specifically- giving a fixing point for boarding a steel with either plasterboard or some kind of...
Use thistle bonding plaster to build up the holes to the right level. Personally i would probably remove the window/door trim if it looks like the...
Im gonna say it is a spur as im sure it only has one cable going into it-it would loop onwards if it was a ring wouldnt it? Im not too sure tbh,...
Trouble is mate where the wire is connected is now buried behind fitted wardrobe units that cannot be removed, so i can only access the loose end...
Im replacing 3 downlights in my newly refurbished built in wardrobe and they are robus 240v gu10 led's(were previosly g4 run on a transformer) but...
If the beading is internal then you wont be able to remove the gasket as it should be fixed/non removable, or co-extruded on newer windows. As...
Separate names with a comma.