Has anybody used henderson sliding door gear for wardrobe doors? I need to basically partition off a room with sliding doors across 4m, and am...
Just fitted two of these taps, one in kitchen and one in utility room of a bungalow:...
OK, now that's got your attention! I am fitting a kitchen for a customer and need a bit of advice on under unit lights. Before you all start, my...
A mate of mine has laid some stone floor tiles, i don't know what they are but they are about 3/4 inch thick, black and sort of look like slate....
with all the nice weather lately i've been doing a lot of garden decking, and i've been looking at ways to speed up the process. Up till now...
I want to put 4 of the little mushroom-style garden lights up each side of my garden, which is about 30m long. Got a set of the low voltage ones,...
Afternoon fellas, I'm fitting some high gloss worktops tomorrow, and have been told that they are a b***d to fit as they chip very easily. Any...
Quick question before I plough into it this afternoon: When dot and dabbing plasterboard onto brickwork, does the brick work need priming with...
Is it necessary to lay a DPM when fitting laminate onto a concrete floor that already has a DPM incorporated? Always have done before, but was...
ok, i know this has been done to death, but i need to tile a floor which has vinyl floor tiles stuck to it. I have searched the forum and read...
When cutting mason's mitres for worktops, how do you adjust the jig to allow for out of square corners? The few I have done have been close...
I have just got a job to do a small kitchen refurb (new worktops, sink, hob etc) and the owner wants to replace a single built in split-level oven...
I have some tiles in my hallway that are in need of some restoration, but i don't know where to start. The tiles are black and white, laid in a...
I've been asked to build a ramp between two floor levels, about 1.5m long with a rise of 250mm. It's in a dry cleaners, and they need a ramp so...
I am thinking of buying a table saw, and have got my eye on the elektra beckum pk200. I am after it for general woodworking, and would like...
I am replacing a timber window with uPVC. Cavity wall, both leaves are brick. There is no lintel above existing window, which is about 1.2m wide,...
I have just oiled my beech block kitchen worktops with tung oil, and they look great. So just a simple matter of siliconing between the worktop...
Separate names with a comma.