Hi JP. The SACS tool is the same design as a tube cutter except for the "V" shaped groove in the rollers to allow for the lengthways cut in the...
Are you sure you can score the armour with those plumbers pipe cutters BB?..never tried it but can envisage then not working..or maybe working...
Ridiculous price of £90 for a tool that performs the same job a plumber's tube cutter fitted with a blade wheel for cutting stainless steel tube....
ProDave's suggestion sounds more probable. BB
Doesn't make a lot of sense. If the cold feed to the shower is from a tank and the water to refill the hot water cylinder that supplies the...
A bit more information would help. Is your hot water supplied by a combi? BB
Head of water was only about 6ft. I didn't say it was necessarily wrong for low pressure systems, but it is for very low pressure systems....
I think it depends on the printer. For printers where the printhead alignment can be performed without the printer connected to the computer (by...
Fluidmaster is absolutely the wrong filling valve for very low water pressure, as I found out when fitting a bathroom suite where the toilet...
Forgot to say, you should definitely not be installing a twin impeller pump. BB
The answers you have received are not very helpful. Saying "no, no, no" doesn't actually tell you waht you should be doing. You cannot pump the...
Tom & Tony, it's quite interesting what Screwfix is selling. The John Guest cutter is £16.61 and says it cuts up to 22mm pipe, whereas the...
barbels1, if you are talking about the drill bits that I have recommended, yes they will. They work better if you use water as a lubricant to keep...
The bellpushes are not particularly well made. Sometimes inserting the lamp, distorts the terminals and prevents contact being made when you press...
I would go for one of these, where the cutting edge is continuous and there is no chance of snagging when you break through: * Although in...
I just looked on the Screwfix site and it appears that the Erbauer core drill bits are TCT. I certainly wouldn't use one of these on a basin. You...
Your problem is the shower head. The Salamander pump that you have installed can pump approximately two gallons a minute at 2 bar pressure....
Jaw, the guy that said this was talking complete rubbish (and can't spell either): a megaflow would be your best answer, you could fit it in...
a megaflow would be your best answer, you could fit it in place of your emursion take and you would never run out of hot water What complete...
The charger has to be at a higher voltage than the battery to be able to charge it. The voltage of 33V may drop as soon as a load is applied to...
Separate names with a comma.