The previous owners of our house had a hot tub, with a dedicated supply, and a small external consumer unit in proximity to the tub. That unit...
Hi there, I’ve had to temporarily remove some lighting cables to sister a joist. Whilst disconnecting them I realised that a lot of the grounds...
I have a Viessmann vitodens 100-w 30kw being controlled by a EPH CombiPack4 wireless thermostat. I need to move the receiver because it is...
Is it OK to clip cables to the underside of exposed joists in a cellar supporting the floor above? (I can't think of a reason why not, the joists...
Hi all , I'm buying a vonhaus 6 gang switched surge protected extension cable but it's got 2 metres of cable , I only need 1 metre , it's not got...
Is it worth spending a few quid on a junction box to house this bit of cabling here below floorboard or just electrical tape it?
Hi, please can someone post me a link to purchase a cable suitable for an AEG induction hob that has a fuse rating of 32amps and 7.3kw elec...
Hi All, i need to change the 1no Ceiling Rose in the bathroom to 4 x Downlights. I have access in the loft to the 3 Cables running in and have...
Evening everyone I recently changed a consumer unit in a property and I moved some internal wiring as I was happy with the order of circuits on...
Hi, I'm looking to dig a couple of trenches for some cable ducting under the driveway - one trench will just have CAT5e, the other will have...
hey all looking for some advice on where to go next, our tumble dryer plug has burnt out at the fuse, had a 13AMP in it which is connected to a...
I want to use this cooker cable to power 4 induction hobs rated at 3kw each. Is the picture I've attached a safe way to do it or can I even do it...
Is there a minimum height from ground to have a 4 core SWA electrical cable installed on an external party wall (shared with neighbour) to comply...
Hi, I want to add power to my shed. Shed is 9m away from the socket in the house. (1) If I run 2.5mm armoured cable from an existing double...
My neighbour has clipped an extension cable overhead a shared access. This extension cable goes from a 240V AC socket within their property. This...
Hi I’ve recently moved a steel portacabin from one part of a site to another. The electricity supply was via armoured cable above ground from a...
I am levelling and re boarding my ceiling and so have to reorganise the spotlights layout so everything is nice and aligned in a grid...6...
Just watched a video on YouTube by the good lads at eFIXX. They did a good video on the Tuff sheath cable. Just curious as what clips you would...
Hi all My electrician installed by request a shaver socket in a draw for me (see pic) However its fed from a decent size mains cable so when I...
I'm making a DIY electro magnet. This magnet just consists of (1) bare bobbin/spool, (2) single core copper cable. Once (2) is fully wound around...
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop
