Hi, I’m looking to remove the stud wall from under the stairs to put a washer dryer underneath but unsure if any of the beams are supporting any...
Hi everyone, could really do with some input into some problems I am having with difficult clients. I will give an outline of the case and what...
Just fixed my Dewalt DC618 nail gun but as I was putting it back together the nail loading spring fell out and I haven't a clue how it goes back....
Hi! ive what bought a new house and the upstairs bedroom ceilings has a curved edge, this is due to the roof apparently, is there a way to square...
Washing machine makes loud knocking noise on 1400 spins (transport bolts are out and machine is level) I have 12mm laminate on 5mm foam underlay...
Hi, been looking at the Dewalt Toughsystem 2.0. Any carpenters/ joiners reccomend these for powertools & accessories etc? Currently have my...
I have a tall roller shutter unit on the kitchen which got stuck. I cannot open it more than 30 cm and then it rolls down (photo attached) so I...
Hello Members, Introduction: currently serving Military (para) based in south Wales, leaving towards the end of this year. Topic: Transitioning...
Hi there's a gap between the floor and the skirting/ wall in my room that's about half way across and it does feel uneven to me. Ive had lots of...
Hi all, I need to make a large sliding door 2600 height and 860 width. my question is shall I use air dried oak or pine for the main structure...
[ATTACH] [ATTACH] [ATTACH] Hi, I am wanting to shorten my dining room table, so I had a look at it. I found metal strips in the middle and on...
Hi all, meant to be doing a deck in a few weeks time. customer is having an extension built and want a deck 7m out from the extension. They want...
Hi guys, Recently had a kitchen fitted which has been fairly stressful. We have managed to rectify many things although I am concerned about the...
Hi all i have been a carpenter 15 years now and for the majority iv been employed. Im now going into the realms of self employment and will need...
I need to get the below work done in southend-on-sea, anyone advise what a fair price should be? Labour only, fit 10 of flush ply fd30 internal...
I am replacing a 35mmthick door with a 40mm thick one but doorstops of course are 35mm. If I rebate the new hinges in from the jamb an extra 5mm...
Its my first time making shaker cabinets, I’ve used 18mm MDF, they’re pretty big (980x670mm) I can’t stop the door from sagging on the top right...
Hi All, I am a bit stuck. If any one can give some advice please. I will be fitting some skylights on a lean on kind of roof. Its just some old...
At which part of my renovation stage will the carpenter’s installation take place?
Separate names with a comma.