Recently had a porcelain patio put down (good job overall as far as I can tell). They added concrete pads underneath as we’re now building a...
Hello all, I am in need of guidance and advice on the process as to what i need to do to determine if I can build a 2nd storey on top of a side...
I am in the process of building a 3-sided wall, but I am stuck with not knowing how much Concrete (B&Q 25kg bag) and Mixed Aggregate (B&Q bulk...
I am currently building a small 10x9ft small block shed that will have a pent roof with the highest point at 8ft in height and lowest 6.8ft. It...
Hi all, Not sure if this is in the right place....but worth a shot. I've discovered a mini sink hole between the house and patio. The hole is...
Hi, im building a deck for my neighbour. When i built our deck i did it the proper way and honestly it could survive an earthquake but my...
Nearly ready to pour footing of around 18m3 Should be able to get readymix truck right up to footing edge in one corner Question is do i move...
Hi All, First time on the Screwfix Community forum, although I have read lots of posts via google searches. My Question, I am looking to build...
Hello all, I have inherited an extension job, long story but original builder is out of the picture. It is rather large and going to be timber...
i am currently building a deck and today dug all the holes for the footings. I dug them 85cm deep and 20cm wide. My plan is to add gravel at the...
Hi, so i am currently building a deck. My plan was to have concrete footings below the frost line at each of the corners and then one in the...
Hi want to build raised bed in garden out of breeze bloc 1ft high and 8 meters long what size footing would I need please? I've looked online but...
Hello, Myself and my partner are in the process of buying our first house. The house we have identified is quite small however has a large...
Hi guys in the process of building a small garage in my and as it is under 2.5M, far enough away from the house ect so no planning is required....
Separate names with a comma.