heating

  1. E

    How to clean fleas out of radiators ?

    So, we moved into a new flat and the radiators are filthy. The radiators aren’t the type where you just slide the side off, they have screws on top. I can’t figure out how to take it apart to clean it thoroughly so I’ve bought a radiator brush. The only problem is, the heating was broken up...
  2. N

    problems figuring out rad order in a small flat

    I paid to have a new boiler power flush and balance. On the day a chemical flush was used. A magna clean was also fitted. But they never balanced the system and stopped responding to calls. I include a picture of the layout. all pipework from the rads goes into corner boxes and up except the...
  3. S

    Radiator not getting hot

    Hi, I have one radiator in the house (not even on the top floor) that is not getting really hot, but we've realised now, that if we close other radiators on that floor, it gets hotter. So it must be that the maze of pipes (22mm and 15mm) wasn't probably done correctly and there is not enough...
  4. S

    Help with confusing Boiler issue (no timer)

    Bit of a weird one (sorry for the complete layman wording) We've just bought a house. Boiler is outside, has a small black and grey thermostat attached to it. (Picture attached) Has an IBO NOVA 25-40/180 pump attached. (Picture attached). There is from what I can see NO TIMER inside the...
  5. A

    Time to repipe house?

    Hi, First time posting and a novice looking for advice! We moved into a semi detached 4 bed house 2 years a go. For 2 winters on the trot we’ve had to flush our central heating system. First year the rads were taken off and flushed with a hose. This seemed to work for a while. Second year a...
  6. M

    Underfloor heating weirdness (years later)

    Hi all, this has now been going on for nearly 3 years, if not 4. My underfloor heating doesn’t work properly, it hasn’t been heating up properly, and my plumber has tried to convince me that it is. I’ve sat with it this afternoon and I’m 100% sure he’s wrong. When I say “it only gets warm when...
  7. M

    Underfloor Insulation

    Hi all, I am looking to install some insulation between the joists under the suspended ground floor of my house. Ive decided to go with Rockwool after doing some research online and weighing up the pros/cons of different methods. The plan was to create a mesh 'hammock' for the Rockwool to sit...
  8. P

    It´s that time of the year..... smart heating....

    Not sure this is the right place, but here goes... Recently moved in as 2nd tenants to a new build, it has a Vaillant combi boiler, and dual zone thermostats - never had 2 thermostats before. Whilst the boiler is in the kitchen there seems to be thermostat labeled pipes and control in the...
  9. Dave777

    1" straight male to male hex brass fitting imperial?

    I have taken a boiler out of a Rayburn and need renew the fitting. It has a straight male to male threaded fitting where a 28mm brass compression fitting will screw onto it. It seems though that the thread on the fitting coming from the boiler is possible an imperial one which might explain why...
  10. F

    Back from holiday and a horrific smell of damp in the ensuite bathroom

    Hi all, Per title - recently went on holiday for a week and we came back to the worst smell of damp in the ensuite bathroom! We’ve never noticed before - new build, moved in early April 2022 as a brand new property. We always have the window open (or at the very least the window vent) and...
  11. S

    Clueless and looking for advice on boiler & gas system

    I recently purchased a property and have zero idea on how the gas/boiler system works (photos attached). Hoping for someone with more expertise to give some advice as I've no one else to ask. Boiler with valve & switch: Boiler brand on top: Pipe with meter & valve directly below boiler...
  12. Dave777

    Rayburn Oil Pipe Size

    The oil that comes through the copper pipe connects to a steel pipe about 10cm long that goes to the burner but that pipe has a bore of around 8mm, is this too big? I cleaned all the carbon build up in that short bit of pipe expecting to reveal a hole of around 4mm not 8mm?
  13. Dave777

    Rayburn Water Tank?

    Does a rayburn that heats water in this case to one radiator and the cylinder I think have a separate header tank? I haven't looked properly yet but I can see the over flow from the rayburn goes to the main water tank?
  14. L

    Vaillant boiler advice

    Hi everyone, hoping to get some advice on some Vaillant boiler models. Looking to get an Ecotec with the stainless steel heat exchanger, but can’t find any info on differences between the Sustain and Pro models. Anyone know what the difference is here? Thanks
  15. A

    Large holes through joists - advice please?

    A tradesman has drilled through joists for heating 22mm pipes. One joist looks particularly bad as I think they are too large holes as shown in photos. I need some advice to feel reassured if this is normal and can leave it as it is or if the joist needs some reinforcement with steel plates or...
  16. T

    Oil Boiler Size

    Hi I am about to order a new oil combi boiler and installation, and I am confused over what size boiler. I got three quotes, two of which quoted in person and said two different sizes. One suggested 18/25 and the other a 26/35. Putting aside the cost difference of the boiler, the engineer...
  17. M

    Install hive to ideal mini c24

    Hi, I’m looking to install a hive to ideal mini c24 boiler. Combi boiler I know the live, neutral and earth are taken from the boiler. It’s the other wires that have me stumped as the ideal has 2 wires for a stat. any tips are appreciated.
  18. J

    Wiring Smart Thermostat from Old Battery Thermostst

    Need some advice as to how to wire up my new Smart Thermostat (picture 1 below) My Old Thermostat has three wires red, blue and yellow( taped red for live) and runs on 3V (see picture 2) The new Smart Thermostat needs 240V independent for 3 and 4 as it is a dry contact. Just need...
  19. D

    Hot and Cold Radiators

    Hi When my central heating is on all the radiators seem to work fine however when the heating goes off the boiler stays on and the upstairs rads stay hot but downstairs go cold. I did have a new rad fitted in the upstairs bathroom about 6 weeks ago could be part of the problem? Thanks in advance
  20. P

    What receiver will work with Danfoss tpone-rf 087N785300?

    Hi, I need to replace my receiver for my central heating which is broken. The thermostat that it's been connected to is a Danfoss tpone-rf 087N785300. Does anyone know what makes/models of receiver can I use with this? Will any work or does it have to be a particular one? Thanks. PS. It's cold!
Back
Top