howdens

Hi All, This is my first thread, and I need a hand here I have three major issues with my cabinets, but let's just focus on one for now... I've bought Howdens' drawers to fit into BnQ cabinets. Not realising that they come with normal runners in the box, I bought soft close runners from...

Hi All, I’m after some advice for fitting Howdens granite support rail please. I’ve got the rail and the two fitting pieces. Can anyone advise how I’m supposed to orientate then please? Looking at the picture online, the open section seems to face into the cupboard, however if that’s the case...

Hello community. I just had a set of fire doors from Howdens installed. Oak veneer, unfinished and not primed. Would like to finish with oil or wax rather than paint, lacquer or varnish. I know there's plenty out there, but I'm wondering if anything is suitable. The doors came with a sticker on...

Hi all, I am installing a set of howdens drawers and an integrated fridge freezer next to each other. The top of the drawer cabinet is 5mm from wall (bottom touching). However at the top of the fridge cabinet, it is nearly 15 mm out. I have attached photos. I was going to trim 5 mm off the...

Hi all, I am fitting my first Howdens kitchen. What gap would you put between a range 5 hob cooker and the cupboards either side? Secondly, if there is a gap between the end panel and the wall (due to a wavey wall), what do you do? Fill it? I am talking about at the end of a run for the end...

Hi there. Planning to replace my kitchen after 20 years. It's probably a small-medium sized one. I'm not looking to spend much at all, my budget is something like 4k (worst case 5k), and most basic modern kitchens I was interested in are perfectly well within reason e.g £1600-2600, the only...

I have some of these panels above and below an integrated kitchen tower from Howdens. I’m replacing the oven and had a quick look but not sure how to remove the fascia panels (I think that is what they are called according to the Howdens catalog) Any tips or guidance much appreciated. Googling...

Hello, can anyone advise us please. When Howden's came to talk kitchens, they said we could change the depth of their tall larders to something like 350mm (so we can comfortable sit a dinner plate on the shelves). We want to put the tall cupboards in alcoves which aren't very deep. Can this...

Recently has a joiner come and quote me for supply and fit of 10 internal doors. Initially wanted the quote based on Howdens Dordogne oak doors, but he mentioned the Howdens Genoa too and stated the only difference is the slight recess of the 5 vertical panels, but they'd work out cheaper than...

Quick question guys Re-fitting a kitchen for a mate with old stock Howdens base units and trying to get some made-to-measure doors. The base units are 1005mm - not 1000mm. Is this usual for Howdens? What width doors would fit on 1005 base units? Just insane - not mentioned in any of the...

Has anyone fitted a Howdens extractor hood? I wish to know how to screw it to the wall as there are holes which look to have inserts missing. I bought the unit second hand and have even asked Howdens if there is a kit for fitting it, but was sent a bracket for the chimney.

So while we were fully convinced that we would go with a Howdens kitchen, we got roped into a 70% off kitchen deal with Betta Living. Visited a few showrooms in Lakeside and we were very intrigued by the quality of design. The sales guy did the usual measure up and design. It was a £20k kitchen...

Hello Can anyone tell me the heights I need to fix the runners at for a pan drawer unit from Howdens. Apparently should have had a diagram? Many thanks in advance :)