Hi Guys, I was wondering if anybody can help me choose the correct lining/frames size for my fire doors? I have an opening in my 100mm block...
I am about to line a workshop in 12mm hardwood ply. My question is which type of screw is best for this the one with a screw thread all the way...
Had room newly plastered. Solid exterior wall has always caused problems with condensation and mould so would like to put up Wallrock KV600...
After working with it a bit i can see the value of insulating paper for external walls. The 3mm Wallrock Thermal Liner is what i generally use....
I've got to replace 10 doors in a house and replace them with firedoors, The problem is its a old-ish house and i cannot find the correct size...
Hi all, I'm looking to wallpaper the plasterboard in the picture below. Its straight edge plasterboard but there are some areas that arnt perfect,...
Is it ok to (dot n dab and hammer fix) hardie backer type cement board onto solid external brick walls ready for skimming, rather than standard...
Hi All, I have a single skin, detached 1960's garage, solid, flat concrete roof which has been covered in 1/2" bitumen sheets, original wooden...
Hey guys, I know this question has been asked a couple of times but I just wanted to check as my question is a little different. I’ve hung lining...
Hi I have a issue with a switch screwing in to the dry lining box. One side screw in properly and the other screw holder just broke. I tried...
Hi all I have finished building a 5x3m workshop which is made of 2x4 Timbers, wrapped in breathable membrane then batterns on top of that and...
Separate names with a comma.
Forums
Facebook
Twitter
You Tube
Instagram
Shop
