I have a combi boiler with pretty poor mains pressure (we're at the top of a hill). Currently have a mixer shower in the ensuite that works fine,...
I have been facing central heating low pressure on unvented hot water RM Cylinders but can't see any leak on the PRV, expansion vessels and...
I'm hoping someone might be able to help figure out an issue that's been driving me mad. We have a British Gas 330+ boiler and a Grundfos UPS3...
Hello. I am having to change my kitchen tap. We have a gravity fed system, however the water to the kitchen tap is coming from the mains, not from...
Hi all, I'm brand new to this so I apologise in advance if I'm asking a question that has already been asked, but looking through similar posts,...
We have moved into a circa 20 year old proprty that has two mixer showers serviced by a dual pump. The hot water tank is on the same floor as the...
Hi there I’m trying to repressurise my boiler as the radiators on my 3rd floor aren’t heating fully. I’ve spent hours reading the manual and...
Hello Just looking for a bit of advice here. I have a cold water tank in my loft and a hot water cylinder in my cupboard and the boiler is...
Hi there, Our power shower has had very poor pressure for a long time, so I decided to bleed any air out of the system (which there was a lot)....
Hello, you guys have helped in the past and hopefully you can again. I have installed a second bathroom on first floor as I live in a house where...
I have had a pump installed on my shower. It is on a gravity fed system. Whenever you have the shower as hit as possible it's fine, when you try...
The Bathroom (Upstairs) has such poor water pressure that the taps are no better than a trickle. The bath and basin have had their filters removed...
I've googled so much and I have no idea. This is the mains feed, all of the flat head sections on the pipework are knackered. We moved in 2...
Hi guys. We have quite low hot water pressure in the kitchen tap. Generally have this problem in the flat as its a very old immersion heater...
Hi, I have installed a sensor tap in the bathroom, the cold works just fine on mains 3bar but even after installing a pump on the hot in the...
Anyone know where I can get freestanding bath taps to work on 0.3 bar or below ?
Separate names with a comma.