Hi all, I'm considering building a retaining wall with railway sleepers sunk vertically. At its highest it'll be 750mm, backfilled to this height....
I’m looking to add weep holes to a 1 brick thick 1.2m high earth retaining wall which forms the house boundary on 2 sides, to dry out the earth....
Hi, We've recently had built a retaining wall 5ft H x 59ft L to level off our garden. 400 standard breeze blocks used, double wall, and have...
I have had a 2ft wall built on my back garden that is going to be retaining a patio area of indian stone but there are no weep holes put into the...
Hi, I was after some advice please on whether the gabion wall shown in the attached photos is likely to fail? It looks like it has bowed already...
I have read some similar threads on here, but they do not appear to give me the solution to my specific problem. I am 1m below my neighbour....
I have built a thick retaining wall to replace a thinner one. The ground level is about 1m, but I have built it taller to block my neighbour as...
I am building a terraced patio. 2 levels with a stepped concrete footing and base built from blockwork. Base filled with hardcore and then slabs...
Hi, There is a large retaining wall in my back garden, it’s about 1.5m high. The wall is hollow 9inch concrete blocks filled with concrete and...
The higher ground level is 0.80m to 0.85m above the lower ground level. We would like to replace a retaining wall that is already there. We...
We are looking at building a retaining wall, as we are on a small budget we are considering doing it our selves. If this is too expensive I will...
I am looking to make a retaining wall that is approx.7m long and 1m high. I would like to have a go at making this myself but it will be the...
Hi I have a retaining wall in my garden that is quite old and has a few bricks missing (i think where water and soil pressure have worn them...
I intend building a small conservatory. Because of the U shape of the house where I intend building it, two and a half walls will be the existing...
Separate names with a comma.