Bending Roofing Sheet

Discussion in 'Other Trades Talk' started by Iain in Byfleet, Mar 14, 2020.

  1. Iain in Byfleet

    Iain in Byfleet New Member

    Hi I have acquired some roofing sheet that is a sort of box profile these sheets are 17ft long and I want to make a right angle bend down the hole length to make my garage roof have a lip over the edge of about 8 inches any ideas.

    Iain
     
  2. gadget man

    gadget man Screwfix Select

    Not sure if you can bend it successfully, but there are all kinds of end profiles available so maybe they do a 90 degree bend?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice