Boss adaptor removal.

Discussion in 'Getting Started FAQ' started by happy chapper, Sep 26, 2021.

  1. happy chapper

    happy chapper Member

    I am replacing shower waste, 32mm too small 40mm too tight. The boss adaptor is solvent welded to waste is it possible to remove this and get a new adaptor. Thanks.
     
  2. pppmacca43

    pppmacca43 Super Member

    Photos would be good
     
  3. happy chapper

    happy chapper Member

    I had another try, I put a chamfer on the end of 40mm pipe + silicone spray a bit of wiggling ......job done. Thanks for your interest ppp.
     
    pppmacca43 likes this.

Share This Page