Hobby mill recommendations

Discussion in 'Engineers' Talk' started by Danny32, Jun 3, 2021.

  1. Danny32

    Danny32 Member

    I’m currently building a small workshop in my single garage and am after a small hobby mill. Just wondering if anybody has the Clarke CMD10 from Machinemart.
    Gear driven chuck isn’t ideal but space is tight so needs to be quite small.
    Have also looked at Sieg from Arc Euro Trade.
    Any help appreciated.
  2. Danny32

    Danny32 Member

    Looks like nobody uses them. I do need one and somebody recommended a hobby mill over a pillar drill.
  3. CGN

    CGN Screwfix Select

    probably better suited forums to answer your questions. Good luck
    Danny32 likes this.
  4. tinkerbell60

    tinkerbell60 New Member

    CGN and Danny32 like this.
  5. Danny32

    Danny32 Member

    Thanks, good idea. Have signed up

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice