LED Tape in Kitchen - advice please!

paul5511

New Member
Hi,

I want to upgrade the existing LED tape in my kitchen to some that are a warmer light and dimmable. I've bought some new dimmable tape along with receiver unit in order to control light brightness/colour with remote control.

I was hoping to install the receiver after the existing driver - but am a bit confused by there being two outputs from the driver, each powering different set of strips. Is this normal? I thought the driver could only handle one output.

Very basic (sorry) diagram of the existing installation:
Screen Shot 2021-06-24 at 17.48.14.png

My question is: can I safely attach two new receiver units to each 'output' of the driver?

Screen Shot 2021-06-24 at 17.48.24.png

This is the driver.

IMG_1011.jpg
Thanks!
 
Presumably the outputs are connected in parallel, so both lights will receive the same voltage.
Your proposal looks fine, the only considerations will be matching the voltage to the receiver (they are often 12 rather than 24v) and the total power consumption doesn't exceed 50w.
 
Back
Top