Looking for pipe with 90mm inner ø

Discussion in 'Plumbers' Talk' started by Boreal, Nov 26, 2018.

  1. KIAB

    KIAB Well-Known Member

    3D printing is far from it's infancy,quite a few firms around that offer it,no idea to cost.
    Would look at printing in ABS, it will give you high strength, PLA might be ok,but can deteriorate if in contact with water.
     
  2. Boreal

    Boreal New Member

    I'll look into it, but anything custom is bound to cost a lot. Will still be on the lookout for something off the shelf. Appreciate the suggestion however.
     
  3. KIAB

    KIAB Well-Known Member

Share This Page