Plasterboard Single Skin Outhouse

Discussion in 'Builders' Talk' started by ZapBranny, Jan 28, 2015.

  1. ZapBranny

    ZapBranny New Member

    Have an outhouse attached to the House built with single course of bricks on three outside walls.

    I want to try and insulate it and not have it so damp. Whats the best way to do this?

    Moisture resistant plasterboard dot and dab on to the bricks?
     
  2. Mr Rusty

    Mr Rusty Well-Known Member

    Whether its the right way or not, when I put an office in my garage I in effect built a stud wall inside the single skin brick. The outer side of the stud was a DPM the inside plasterboard and the stud cavity filled with insulation. With an air cavity between this and brick wall and insulated floor and ceiling, office is toasty.
     
  3. ZapBranny

    ZapBranny New Member

    Sounds good thanks.
     

Share This Page