Screwfix's Recent Activity
-
Screwfix replied to the thread New kitchen tap.
Probably not too difficult. A pic or two might help.
May 8, 2024 at 8:57 AM -
Screwfix replied to the thread new bath install,.
Same. I just pull the film back a little from tap holes/waste/the two edges going against the walls. Not sure how having the protective...
May 7, 2024 at 12:38 PM -
Screwfix replied to the thread Can't remove hot water cylinder flange.
One technique - after heating it, get your (largest) adjustable spanner straight on it & tap the end of spanner with a hammer (in the...
May 5, 2024 at 1:41 PM -
Screwfix replied to the thread Can't remove hot water cylinder flange.
I’d get the top nut & pipe out the way first. Then as mentioned above, apply heat if necessary.
May 5, 2024 at 1:17 PM -
Screwfix replied to the thread Stop button on tap.
How does the hose connect to the tap head? If ½” either end, you might be able to insert an isolator, or possibly a diverter with one of...
May 4, 2024 at 11:21 PM -
Screwfix replied to the thread Advice Needed: Shower Pump for Low Water Pressure.
Gonna need at least three elbows to site the pump under a bath, so I would re-pipe in 22mm personally. You’re going to have to drain...
May 3, 2024 at 12:57 PM -
Screwfix replied to the thread Advice Needed: Shower Pump for Low Water Pressure.
If the pump is to be sited at the foot of cylinder, then it should be fine. Do the new cold feed from the CWS tank in 22mm though, and...
May 3, 2024 at 11:28 AM -
Screwfix replied to the thread Towel Radiator Tail Extension Piece Needed?.
The tails I linked to will work, I’ve fitted plenty of them. The title/listing is a bit misleading, but note it says “union” & if you...
May 3, 2024 at 11:13 AM -
Screwfix replied to the thread Towel Radiator Tail Extension Piece Needed?.
Either fit it as the previous owner did, or as you suggested, use a couple of extendable tails. These should do the trick -...
May 2, 2024 at 10:16 PM
Forums
Facebook
Twitter
You Tube
Instagram
Shop