WANTED: Rip Fence

Just got given a working Delta 36-525 10" table saw with stand, it's too good to skip, but I'm missing the rip fence.
Spares are non exsistant,a bit of googling found a Ryobi model that is identical ,so has anyone got a broken/dead Delta 36-525 or Ryobi BT250ET table saw lying around for a spare rip fence.

 

You don't see them that often, & if they do appear, they want silly money for them.
There a Ryobi BT250ET on the bay today, they want £110 for it.

The saw I got was used two or three times,then covered with a sheet & sat in a shed unused for 10 years.

 

Thanks for reply Phil, according to Ryobi the BT250ET is now obsolete & the fence isn't available.

 

Been doing that, but a lot of hassle setting up each time for different cuts.

 

Thought about that, but the guide for the fence to slide along, has a stupid profile,have thought about changing it for round pipe or some angle.
Will post a photo tomorrow, explains it easier.